From the course: Revit 2019: Essential Training for MEP (Imperial)

Unlock the full course today

Join today to access over 24,000 courses taught by industry experts.

Adding sanitary sloped piping

Adding sanitary sloped piping - Revit MEP Tutorial

From the course: Revit 2019: Essential Training for MEP (Imperial)

Start my 1-month free trial Buy for my team

Adding sanitary sloped piping

“

- [Instructor] Sloped sanitary piping. This is the tough one. I used to get yelled at about this. But to be honest, when it first came out it was basically unusable, but after the few upgrades it got a lot better, to now where I don't really think it's that bad. So let's get started. In projects, let's go open. I'll grab Plumbing Project_sanitary, then I'll click open. Let's make sure we're in the typical lavatory plan, but I don't want it to be HVAC. To change that we'll go in our properties, and I want our subdiscipline to be none other than plumbing. Apply. That's going to put us in the right spot. The next thing I want to do is just throw a fitting in here. Go to the systems tab. Let's click on the plumbing fixture button. Click the drop down on the properties. Pipe connector sanitary plumbing fixtures. So we'll grab this one. Let's put it right next to the toilet and then hit escape a few times. Select the fitting. For the elevation, let's put it at 1 foot 6. Remember, we can…

Contents